Homebrew hints 2

This page illustrates the use of wide PCB homemade strip board for prototyping and quick build projects.

101-jig-with-marker-holes

102-jig-with-blank-pcb-ready-to-stripe

103-stripes-lined-up-with-holes

104-stripes-cut-away

$The striped side of the board is now complete. Leave stripes out if you need non copper space, or use narrower strips for smaller spacing such as 0.1\".$

106-double-side-pcb-rear-covered-with-masking-tape

107-striping-wiyhout-a-jig

108-ready-to-etch

109-etching-finished

110-clean-and-wash

111-clean-and-wash-rear

113-clean-up-edges

114-square-off-edges

115-layout-your-circuit

116-mark-drill-and-slit

117-drill-through-earth-holes

118-wire-links-in

119-solder-parts-in

120-bend-leads

121-mount-ic

122-alternative-ics

123-ready-to-test

124-finished-amplifier

131-the-bfo-board

132-bfo-board-finished

135-relay-board

[Show picture list]

Welcome to my website.

Here you can obtain purchasing information for the popular RX1 and RX2 antenna Noise Bridge kits.

A low cost, easy to assemble, and very useful item of RF test equipment. Select the YouTube video clips to illustrate some typical RF measurements.

Also available is the sensitive accurate RFPM1 RF power meter and accessories.

Navigate my site for links and general information for Amateur radio operators and Electronic Hobbyists.

73's from Lou,VK3AQZ
Melbourne,
AUSTRALIA

Hit Counter provided by best seo company