Homebrew hints 2

This page illustrates the use of wide PCB homemade strip board for prototyping and quick build projects.

Click on “Show as slideshow“, wait for first photo to load then click photo to adavance to next photo or wait for timed photo change.

[Show as slideshow]

101-jig-with-marker-holes

102-jig-with-blank-pcb-ready-to-stripe

103-stripes-lined-up-with-holes

104-stripes-cut-away

105-pcb-striped-ready-to-etch

106-double-side-pcb-rear-covered-with-masking-tape

107-striping-wiyhout-a-jig

108-ready-to-etch

109-etching-finished

110-clean-and-wash

111-clean-and-wash-rear

113-clean-up-edges

114-square-off-edges

115-layout-your-circuit

116-mark-drill-and-slit

117-drill-through-earth-holes

118-wire-links-in

119-solder-parts-in

122-alternative-ics

123-ready-to-test

124-finished-amplifier

131-the-bfo-board

132-bfo-board-finished

135-relay-board

Welcome to my website.

Here you can obtain purchasing information for the popular RX1 and RX2 antenna Noise Bridge kits.

A low cost,easy to assemble,and very useful item of RF test equipment. Select the YouTube video clips to illustrate some typical RF measurments.

Navigate my site for links and general information for Amateur radio operators and Electronic Hobbyists.

73's from Lou,VK3AQZ
South Gippsland, 3995
AUSTRALIA